![]() ![]() By pulling the tape and applying some tension, it will be easier to cut or tear the strip. If you have trouble tearing/cutting the tape, then it is recommended to apply some form of tension on the tape by pulling it gently while one end is installed on the surface while the other end is still spooled in the roll. Increasing the surface area of application by applying more strips on the object that is to be mounted will also increase the weight holding capacity.Heating the adhesive upon installation will temper it and further increase the adhesive’s strength. If you have a hair dryer or a heat gun, you can also heat the adhesive using its warm air exhaust.Squeegee any air bubbles or gaps that may exist between the surface and the tape. ![]() Make sure to press it firmly through your hands or palm. You can increase the bonding strength by pressing it against the surface.Also, to improve the bonding strength, it is recommended to apply as much tape as possible as the surface area allows. The adhesive liner needs to be removed to expose the sticky side. The Double-sided Woodworking Tape’s adhesive liner is yellow in color while the adhesive tape itself is cream/white. You could use any flat tipped object like your nail or a thin card to initially create a small gap which can be fully peeked to release the liner. Apply more strips by repeating steps 2-5.To separate the adhesive liner easily, you can use any flat tipped object like a card, knife’s edge or your fingernail to create an initial gap between the liner and the tape. ![]() ![]() The tension will make the tape easier to cut.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |